JR X9303 Airplane Transmitter - DJI NAZA-GPS Interface Setup. FAIL SAFE - ATTITUDE - FAIL SAFE - MANUAL selection in the Naza Assistant software. INSTRUCTION MANUAL FOR AIRPLANE. XP9303 Transmitter Features. Sure that the center pin of your JR transmitter is always.

• INSTRUCTION MANUAL FOR SAILPLANE XP9303 9-CHANNEL COMPUTER RADIO SYSTEM. • Section 1: Using this manual.G-8 XP9303 Transmitter Features (Rear).G-13 Section 2: Features.G-8 Battery Cover.R770 Receiver.

XP9303 Transmitter Features R770 (Basic Air and (Internal).G-14 Sailplane Systems). R649 Receiver.

Control Stick Tension Adjustment. • Programmable Mixers.S-32 Model Reset.S-4 MULTI-POINT Modulation.S-5 Programmable Mixers.S-36 TRANSFER a model from the XP9303 – Monitor. S-39 (Transfer function).S-6 Programming a 6-Channel Sailplane by TRANSFER – Transfer the model to another Engineering Manager John Adams.S-40 transmitter or to DataSafe.S-6. • Table of Contents Sailplane Section (continued) Step #19 Aileron-to-Flap.

S-53 Step #29- Aileron-to-Rudder Mix.S-62 Step #20 Aileron Differential.S-53 Setting Up Land Mode. S-62 Step #30 Land Pre-sets.S-63 Step #21 Flap Rate, Camber Mix and Camber Adjust. • Section 1: Using this manual This Manual is divided into three specific sections: In this manual you will find the specifications for the radio Airplane, Sailplane and Helicopter. When writing this and its various components and accessories. In addition, manual we employed three distinctly different individuals guidelines for the installation have been included.

Hear 1 1 6 keygen crack download. • Section 3: Component Specifications Servo Specifications Type DS811 DS8311 DS368 Torque 54 Oz/In 125 Oz/In 53 Oz/In Speed Weight 1.44 Oz 1.87 Oz 0.80 Oz Size (in) (L x W x H) 1.49x0.75x1.52 1.54x0.75x1.36 1.12x0.50x1.17 Ballbearing Motor Cored Coreless Cored Transmitter Specifications Type Airplane. • Receiver Specifications Type 7 Channel SPCM 9 Channel SPCM Model Number R770 R649 Type 7-ch/SPCM-ABC&W/Micro 9-ch/SPCM-ABC&W Frequency 72/75/50mhz 72/75/50mhz Sensitivity(Microseconds) 5 uS Minimum 5 uS Minimum Selectivity 8KHz/5 dB 8KHz/5 dB Weight (oz).75 oz 1.5oz Receiver Antenna 39” for all aircraft frequencies 39”. • “color-coded” wire leads, as they do not apply in this instance. You must make sure that the center pin of your JR transmitter is always connected to the negative voltage for correct polarity RED TO NEGATIVE hookup. • XP9303 Transmitter Features (Front) Mix Switch AUX2 Aileron Elevator AUX4/ Dual Rate Dual Rate Rudder Dual Aux Trim Gear Switch Rate Flap Trim Trainer Button Flap Switch Lever Lever Throttle/ Elevator/ Rudder Stick Aileron Stick Throttle Trim Elevator Trim Rudder Trim. • XP9303 Transmitter Features (Rear) Battery Cover CAUTION: THE BATTERY CONNECTION IS KEYED SO THAT IT CAN ONLY BE PLUGGED IN ONE DIRECTION.

DO NOT FORCE. • XP9303 Transmitter Features (Internal) ELEVATOR TENSION SCREW RUDDER TENSION SCREW AILERON TENSION SCREW THROTTLE TENSION SCREW Control Stick Tension Adjustment Remove the six transmitter back screws as shown on the Adjust each screw for desired tension (counter-clockwise previous page. Remove the transmitter back, being careful to loosen stick feel. • Please also note that unlike conventional mechanical trim The XP9303’s Aileron, Elevator, Throttle and Rudder trim levers, when the XP9303 transmitter is in the off position, levers feature an audible center trim beep. This is helpful no changes can be made to the trim values during in determining the trim levers center position during transportation. • Deluxe Switch Harness to use in the original setup of your aircraft while still – JRPA001, or a JR Chargeswitch – JRPA004, for the in the workshop.